RevLite

Evens out dull skin tone and pigmentation with toning

Available Reservation Date

Weekday(Mon, Tue, Wed, Thu, Fri)10:30 am ~ 8:00 pm

Weekend(Sat, Sun)10:30 am ~ 4:00 pm

RevLite SI Toning+Modeling Mask

Luxury laser: RevLite SI by Cynosure (USA) Brighter skin with PTP mode *5 sessions: ₩390,000 *10 sessions: ₩590,000

198,000 KRW

99,000 KRW

RevLite SI Dual Toning 10 Weeks

Brighter skin, melasma treatment RevLite SI toning+CosJET Genesis+modeling mask

2,180,000 KRW

1,090,000 KRW

Estimated Payment Amount (Additional 10% VAT)0 KRW

RevLite

PTP-mode toning for evenly brighter skin tone and pigmentation

Procedure Description

RevLite SI is a Q-switched Nd:YAG laser from Cynosure (USA) that delivers energy to pigment in the skin using 1064 nm and 532 nm wavelengths. In particular, its PTP mode, which splits a single pulse into two, allows toning while spreading out the stress delivered to the skin. At 3Leaf Clover Clinic, RevLite SI toning is performed on the full face, followed by a soothing modeling mask. For those who also want to care for skin texture and firmness, we offer a 10-week RevLite SI Dual Toning program that adds CosJET Genesis. Energy is adjusted to your concerns, such as melasma, blemishes or dull skin tone, and to your skin's sensitivity. The degree of improvement may vary depending on each individual's skin condition.

Procedure Features

A Q-switched Nd:YAG laser using 1064 nm and 532 nm wavelengths.

PTP mode spreads out the energy to reduce skin irritation during toning.

Used to evenly address melasma, blemishes and dull skin tone.

Dual Toning with CosJET Genesis also cares for skin texture.

Recommended Target

Those whose overall skin tone looks dull

Those with melasma and faint blemishes

Those who want toning that is easier on the skin

Those who want a clearer tone through regular toning

Procedure Time

Approx. 20–30 min (including modeling mask)

Procedure Cycle

5–10 sessions recommended, every 1–2 weeks

Recovery Period

Daily activities possible the same day

Procedure Process

STEP 1.

Consultation and skin analysis — Pigmentation and skin sensitivity are checked.

STEP 2.

Cleansing and preparation — Makeup is removed and protective eyewear is put on.

STEP 3.

RevLite SI toning — The laser is applied evenly across the full face in PTP mode.

STEP 4.

Additional laser — For Dual Toning, CosJET Genesis follows.

STEP 5.

Modeling mask soothing — Heat is reduced and the skin is calmed after the laser.

Procedure Area

Full faceCheekbonesCheeksForeheadChin

Precautions

Apply sunscreen thoroughly after treatment and avoid strong sun exposure.

Temporary redness or warmth may occur right after treatment; this usually subsides within a few hours.

For 2–3 days after treatment, avoid irritating skincare such as exfoliants and peeling products.

Rather than squeezing in extra sessions over a short period, it is best to keep to the recommended intervals.

FAQ

What is PTP mode?

It is a method that splits one laser pulse into two pulses fired a short interval apart, helping to spread out the energy so toning can be done with less skin irritation.

Is it painful?

It is relatively low in pain, with a slight sting or warm sensation, though this varies from person to person.

Can I combine it with PicoSure?

Depending on your skin, a plan alternating the two lasers is also possible; we will advise you through a consultation after your skin analysis.

How many sessions will I need?

We usually recommend 5–10 sessions every 1–2 weeks; the number may vary depending on your pigmentation.